With the rapid development of my country's manufacturing industry, aluminum parts have been widely used in aerospace, automobile, electronics and other fields. However, during the processing of aluminum parts, the problem of cross hole burrs has always troubled enterprises. This article will introduce the application of a new type of magnetic Croatiadeburring machine in the cross hole burr treatment of aluminum parts to improve the processing quality and production efficiency of aluminum parts.
1. Introduction
During the processing of aluminum parts, the problem of cross hole burrs is a common problem. These burrs not only affect the appearance quality of the product, but may also cause product failure during use. Traditional deburring methods such as manual grinding and chemical corrosion have problems such as low efficiency, unstable quality, and environmental pollution. Therefore, it is of great significance to find an efficient and environmentally friendly method for processing cross hole burrs of aluminum parts.
2. Principle and characteristics of magnetic deburring machine
Principle
The magnetic deburring machine uses magnetic force to drive the grinding steel needle and polish the workpiece through the high-speed rotating steel needle. The equipment is mainly composed of magnetic device, grinding steel needle, control system and other parts.
Features
(1) High efficiency: The magnetic deburring machine has a high speed and fast polishing speed, which greatly improves production efficiency.
(2) Precision: The contact pressure between the magnetic deburring machine and the workpiece is uniform, and the polishing accuracy is high.
(3) Environmental protection: The magnetic deburring machine uses water-soluble polishing liquid for polishing, and no exhaust gas is generated, which meets the requirements of green production.
(4) Strong adaptability: The magnetic deburring machine can be used for the burr treatment of cross holes of aluminum parts of various shapes and sizes.
III. Application of magnetic deburring machine in the burr treatment of cross holes of aluminum parts
Process flow
(1) Preparation: Fix the aluminum parts on a special fixture to ensure the stability of the workpiece.
(2) Grinding tool selection: Select a suitable polishing grinding tool according to the size and shape of the cross holes of the aluminum parts.
(3) Parameter setting: Adjust the speed, pressure and other parameters of the magnetic deburring machine.
(4) Polishing: Start the magnetic deburring machine and polish the cross holes of the aluminum parts.
(5) Inspection: After polishing, check the burr removal of the cross holes of the aluminum parts. If there are residual burrs, secondary polishing can be performed.
Application effect
The cross holes of the aluminum parts treated by the magnetic deburring machine have completely removed burrs and the surface finish has been significantly improved. At the same time, the production efficiency is increased by more than 50% compared with the traditional deburring method, reducing the production cost.
IV. Conclusion
The magnetic deburring machine has significant advantages in the treatment of cross hole burrs of aluminum parts, achieving efficient, environmentally friendly and precise deburring effects. With the continuous advancement of technology, the magnetic deburring machine will play an important role in more fields and contribute to the development of my country's manufacturing industry.
